Vortech 1993-1997 5.7L LT1 F-Body - Manual (Page 3)

Installation Instructions
Vortech Maxflow Power Cooler
Congratulations on selecting the best performing and most
efficient aftercooler today... the Vortech Maxflow Power Cooler !
The Vortech Maxflow Power Cooler system was designed as a street/strip oriented aftercooler,
specifically for use on 1993 - 1997 LT1 GM F-Body vehicles equipped with a Vortech Supercharger
producing up to approximately 580 HP. The Maxflow Power Cooler system will fit and work equally
well with other brands of centrifugal superchargers as well as turbochargers, with minor modifications.
As with any power enhancing product, this system is intended for use on healthy, well-maintained
engines. Vortech Engineering is not responsible for engine damage. Installation on new vehicles
will not harm or adversely affect the break-in period so long as factory break-in procedures are
followed.
For best performance and continued durability, please take a note of the following key points:
1. Use only premium grade fuel 92 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until
problem is resolved.
1993 - 1997 LT1 Camaro and Firebird
TOOL & SUPPLY REQUIREMENTS
• Adjustable Wrench
• Open End Wrenches (1/2”, 9/16”, 3/4”)
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Pipe Tape (Teflon)
• Wire Cutters
• Wire Strippers
• Utility Knife
• 3/8” Ratchet
• 5/16, 7/16”, 1/2”, 9/16”, 8mm,
and 10mm Sockets
• 3/16” Allen Wrench
• Soldering Gun
• Hammer
• Hacksaw
IMPORTANT NOTE: The standard water tank/filler system is not designed for use with ice. If an
ice bath type of system is desired (drag racing) Vortech can supply a tank (#8N105-010) specifically
designed for this type of use that mounts in the factory battery location (the battery must be
relocated to the trunk). Part #8N105-010 is a larger capacity tank with a generous opening that
allows for ice fill-up. A drain petcock is located on the side of the tank for removal of melted ice
in between rounds during racing applications.
Before beginning this installation,
please read through this entire instruction booklet
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
31JAN00 V 1.0