Vermona fourMulator - quad modulation engine - Manual (Page 6)

Getting Startet
To ensure top quality, we carefully inspected the module before packag-
ing. Nevertheless, the unit could have been damaged during transporta-
tion. Therefore, we ask you to take a serious look at the module when
unpacking. Do not hesitate to contact us, should there be anything
unusual with the unit or its packaging.
You should find the following items in the box:
• the fourMulator module
• a system bus connector cable (compatible to Doepfer's A100, TipTop
Audio Zeus and others)
• four rack screws 3x6mm
• four flat washers 3mm
• four patch chords (2x15cm, 2x30cm)
• this manual
Setup
The fourMulator was designed to work in modular synthesizer systems
using the common euro rack format. Its power supply, connectors and
dimensions match the specifications of Doepfer's A100 modular synthe-
sizer system and compatible units. To mount the module into your sys-
tem's frame, carry out the following steps:
1. Switch off the power-supply. Safety first: Remove the detachable
power cable from your frame – it is possible that you accidentally
touch the internal power transformer.
2. Connect the supplied ribbon-cable to the module's rear. The corre-
sponding plug socket is protected against reverse polarity. The rib-
bon-cable will only fit in one direction.
3. Connect the ribbon-cable's other side to an empty plug-socket of
your frame's system bus. Make sure the color coded side of the
cable points downwards (-12V)!
ATTENTION Connecting the ribbon-cable with reverse polarity
can lead to damage of your module when powe-
ring the system!
Owner's Manual VERMONA Retroverb Lancet
- 6 -