Vermona fourMulator - quad modulation engine - Manual (Page 14)

(9) Clock output (CLK OUT)
This jack outputs the clock signal. It can be connected to modules such
as step-sequencers, clock dividers or sequential switches.
(10) Clock input (CLK IN)
This jack allows feeding an external clock signal into the fourMulator.
With this input being used, the internal clock is automatically dis-
connected from the modulators. By setting the SYNC switch to CLK, the
external clock will be used.
NOTE The internal clock remains. By removing the
cable from CLK IN, the internal clock regains
control using the previous tempo. This tempo
setting will only be lost when switching of or
powering down the system.
Further connections
(11) Trigger-sequence output (TRIG SEQ)
The trigger-sequence being available on this output is a deduction of the
trigger-signals of all synchronized modulators. At least one of the modu-
lators 2, 3 or 4 needs to be externally synchronized for the trigger-
sequence to be active. Modulator 1 can run freely or being set to CLK.
With multiple modulators being synchronized, the corresponding trig-
ger-signals are combined with respect to the selected clock division fac-
tors. This might sound abstract, but is logic. Please consult the overview
in chapter 1.3 for help. Otherwise, the proof of the pudding is in the eat-
ing. Here, a little practice is more helpful than a detailed description.
(12) Global Reset-Input (RESET)
By using this input, all wave form of all modulators can be reset with a
single trigger/gate-signal. Note that each modulator that uses its dedi-
cated reset-input will not be reflected by the global reset.
Owner's Manual VERMONA Retroverb Lancet
- 14 -