Vermona Retroverb Lancet - spring reverb - Manual (Page 12)

Band pass
The band pass filter is a combination of a low pass- and high pass filter. It
will only let a certain frequency band of the input signal pass. CUTOFF sets
the center frequency for that frequency band. By moving CUTOFF, you set
the pass band for the mid frequencies. The band pass offers a slope less
steep than that of the other filter types. Its efficiency is a little less
distinctive.
The filter section offers the following control elements:
Picture 7: Filter Section
MODE
MODE selects the filter type.
LP = Low pass Low pass filter with a slope of 24dB per octave
BP = Band pass Band pass filter with a slope of 12dB per octave
HP = High pass High pass filter with a slope of 24dB per octave
BALLS
BALLS will emphasize low and higher frequencies in a predefined ratio.
The resulting signal will cut through the mix with increased punch and
bass amount. The high frequency enhancement will be best accentuated
with higher RESONANCE settings.
Owner's Manual VERMONA Retroverb Lancet
- 12 -