VDO WL X1 DW User Manual

Page 18

X1DW

VDO CYCLECOMPUTING

www.vdocyclecomputing.com

X1DW 35

Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
any wheel sizes, the computer works with these
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.

BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using

Confirm the entry with

BIKE 1/SET OK? Confirm with

The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.

How to set the clock:

Using go to SETTINGS/
SELECT. Confirm with

You are now in setting mode
(pressing

for 3 seconds gets

you back to function mode)

Using go to CLOCK/SET.
Confirm with

CLOCK/24-H-MODE (you can
switch to 12-H mode using .
Confirm with

CLOCK...SET HOUR/CONTINUE
Set the hours using .
Confirm the hour setting
with

CLOCK...SET MINUTES/
CONTINUE. Set the minutes
using . Confirm the
minutes setting with

CLOCK/SET OK? Confirm with

The display confirms: CLOCK/SET DONE.
Automatic return to SETTINGS/SELECT.

5.3 Setting the clock

You can program the values on the distance coun-
ter at any time (e.g. at the end of a season).

Using go to SETTINGS/
SELECT. Confirm with

You are now in setting mode
(pressing

for 3 seconds gets

you back to function mode).

Using

go to ODOMETER/

SET. Confirm with

5.4 Setting the total kilometres

ODOMETER/ODO BIKE 1
(use to go to setting for
BIKE 2). Confirm with

ODO BIKE 1 ...SET DISTANCE/
CONTINUE.

You can set the flashing digits
using .
To access the next digit, con-
firm with

. Repeat the steps

until the last digit on the right
is flashing. Confirm with

ODO BIKE 1/SET OK? Confirm with

The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.

5.5 Switch from Bike1 to Bike2

>>> P03

The selected Bike 1 or 2 is shown
on the display bottom left (

Note: The transmitter on bike 2 must have been
set to bike 2 before using it the first time.

>>> P03

Your VDO computer can be used on 2 bikes.
If you switch from bike 1 to bike 2, the computer
recognises the transmitter from bike 2. The
computer then automatically switches to bike 2.
All data are now saved for bike 2. When you use
the computer again on bike 1, transmitter 1 is
recognised. The computer switches to bike 1.
The data are now saved for bike 1.