Ubiquiti Networks airFibe5 - Manual (Page 29)

27
Alignment
Establishing a Link
Adjust the positions of the Master and the Slave to establish a link.
Note: The Master must be aimed first at the Slave because
the Slave does not transmit any RF signal until it detects
transmissions from the Master.
1. Ensure that the following bolts and nuts are loose:
• Four Pre-Installed M10x25 Flanged Bolts on the airFiber radio
(two on each side)
• Four M10 Hex Nuts used to lock the elevation alignment on
the Upper Mount Bracket (two on each side)
2. Ensure that the pole mount is snug yet the four M10 Serrated
Flange Nuts attaching the Pole Clamps are loose enough to
allow rotation around the pole for azimuth alignment.