Tube Tech SMC 2BM Multiband Mastering Opto Compressor - Manual (Page 4)

Lydkraft ApS
Mose Allé 20, DK2610 Rødovre
Denmark
4
6) Apply a signal of 100 Hz, (approx. -20 dBU) to the input and adjust the input level
for an output reading of 0,0dBU.
7) Move t he j umper on t he l ow band si de chai n PCB t o “ ADJUST” and obser ve t hat
the output level has dropped to -10,0 dBU in both channels.
8) If this is not the case, adjust the balance P 6 to an equal reading for both channels.
9) Adjust the gain reduction with P 5, to obtain a drop of -10,0 dB.
10) Repeat step 8 and 9.
11) Adjust the low band display with P 7 so the green -10 LED turns on and the
green -7 LED just turns off
MID BAND:
1) Turn all the THRESHOLD-controls fully counter-clockwise.
2) Turn the MID BAND GAIN-control fully clockwise.
3) Turn the LOW BAND and HIGH BAND GAIN-control fully counter-clockwise.
4) Set the X-OVER LOW at 60 (300).
5) Set the X-OVER LOW multiplier at x1.
6) Set the X-OVER HIGH at 6k.
7) Apply a signal of 400 Hz, (approx. -20 dBU) to the input and adjust the input level
for an output reading of 0,0dBU.
8) M
ove t he j umper on t he l ow band si de chai n PCB t o “ ADJUST” and obser ve t hat
the output level has dropped to -10,0 dBU in both channels.
9) If this is not the case, adjust the balance P 6 to an equal reading for both channels.
10) Adjust the gain reduction with P 5, to obtain a drop of -10,0 dB.
11) Repeat step 9 and 10.
12) Adjust the mid band display with P 7 so the green -10 LED turns on and the
green -7 LED just turns off.
(130711)