Treasure Garden AG19 - Manual (Page 7)

I
M
P
L
K
J
B
A
G
D
E
F
C
Bolts (4)
Washers (4)
Wrench (1)
R
Q
O
H
N
A - Spring Locks (2) G - Support Strut M - Cantilever Arm
B - Top Pole H - Tilt Degree Scale N - Hinge
C - Crank I - Shoulder O - Vega ™ Light Adapter
D - Operating Handle J - Release Knob P - Canopy
E - Crank Case K - Bottom Pole Q - Cross Bars (2)
F - Steering Rod L - Base Pole Clamp R - Bottom Pole Stem
WARRANTY:
Treasure Garden warrants this product
(in residential use) to be free from defects
in original materials and workmanship for a
period of 1 year from the date of purchase.
If a defect in the original material or
workmanship appears during the warranty
period; Treasure Garden will (at its option)
repair or replace the product without
charge.
Limited warranty against fabric
fading, based on fabric grade.
Simply contact your original authorized
Treasure Garden dealer with a description
of the defect. The dealer will verify the
defect and work closely with Treasure
Garden to obtain the necessary service.
In many cases, simple problems can be
solved with a replacement part that can be
shipped directly to the dealer for
professional installation/repair.
In the event that warranted factory service
is required, Treasure Garden will assume
the responsibility of the return freight
charges on warranted product for the first
year only.
Returned product that (upon receipt and
inspection) is deemed to be “not covered”
under our warranty, will be shipped/billed
at your expense.
This warranty gives you specific legal rights,
and you may have other rights which vary
from state to state.
NOTE: Failure caused by unreasonable or
abusive use, or failure caused by neglect of
reasonable and necessary care are not
covered by this warranty.
Additionally, acts of nature (including but not
limited to wind, hurricanes, tornadoes, and
storms) are not covered by this warranty.
Thank you for your purchase of Treasure Garden’s AG19 Cantilever Umbrella.
Please remove all contents from the package, inspect and review checklist.
CAUTION: To reduce personal injury and damage to your AG19, read and follow this
assembly and operation guide We recommend a two-person team for assembly and
disassembly. Save information for future reference.
REQUIRED FOR ASSEMBLY:
• One (1) 1/2" socket wrench or adjustable wrench.
• Four (4) 40 lb. weights - square stones or concrete weights. (160 lb. total weight
needed for support - weights not included) Stones & weights, standard sizes
can be used up to 20" L x 20" W x 1.5" H.
NOTE: Using the cross bar stand without weights will damage your umbrella
and may cause injury.
S A F E T Y P R E C A U T I O N S :
• Close the umbrella in windy conditions or when a storm approaches.
Never allow the umbrella to flap in the wind; this could damage the canopy.
• Do not leave open umbrella unattended. If damage occurs, this is not covered
by the warranty.
• When adjusting the umbrella, make sure that no person(s) or item(s) are close to the
umbrella. This is important to prevent injury or material damage.
C A R E A N D M A I N T E N A N C E :
• When not in use, close and cover umbrella with a protective cover (sold separately).
• Allow a wet canopy to dry opened up.
• If necessary, clean the fabric with lukewarm water, mild detergent, and a sponge.
• Wipe sliding marks on the aluminum poles with a damp cloth.
Winter Storage:
• Store in a dry, protective place.
• Any visible defects must be repaired by a professional.
After the Winter:
• Areas subject to turning and sliding can be treated with a non-staining lubricant spray
(silicone-based).
• Check the condition and function of the umbrella. Any defects must be repaired by a
professional.
6 1
AG19 CHECKLIST