Treasure Garden AG19 - Manual (Page 5)

S T E P 4 Closing AG19
IMPORTANT: When closing the umbrella, the canopy must be in a horizontal position, or
damage to umbrella may occur.
Hold the operating handle against supporting strut and turn the crank counter-clockwise
(FIg. 10) until the canopy is closed. Unlock the umbrella by detaching the crank case from
the support strut (Fig. 11). Turn the release knob (Fig. 12) clockwise; at the same
time, pull the cantilever back by holding the tilt degree scale (Fig. 13) and guide the cantilever
back to the pole.
CAUTION: Avoid pinching hands or fingers while closing the umbrella.
Once umbrella is closed, cover it with a protective cover (sold separately).
S T E P 3 Opening AG19
Hold the tilt degree handle (Fig. 6) on the cantilever and push it up until the shoulder is
reached. Lock the umbrella by attaching the crank case to the support strut (Fig. 7). Turn the
crank (Fig. 8) clockwise until the umbrella is fully opened and the hub (Fig. 9) is at
the top most position.
4 3
Marked
Range
(Fig. 12) (Fig. 13)
(Fig. 14) (Fig. 15) (Fig. 16)
(Fig. 11)
(Fig. 12)
Base Pole Clamp
Slider
(Fig. 6)
(Fig. 8)
(Fig. 9)
(Fig. 7)
S T E P 6 Adjusting the Tilt
Pull the operating handle from the support strut (Fig. 12). Pull the steering rod further away
from the support strut (to a 45° angle) until the steering rod is in the
marked range (Fig. 13).
While still in the marked range, rotate the steering rod to the left or right (Fig. 14), to the angle
you wish to tilt. Push the operating handle straight forward, then bring it back to center position
and lock the crank case onto the support strut (Fig. 15). Your canopy should now be locked
into its tilted position (Fig. 16).
NOTE: If you wish to rotate the canopy 15° clockwise, then rotate the steering rod 15°
counter-clockwise.
To return canopy to its horizontal position (which MUST be done before closing the umbrella)
simply do these steps in reverse. Start by pulling the operating handle slightly away from the
support strut, but NOT into the marked range. Rotate the canopy back to horizontal, then pull
the steering rod into the marked (release) range; which will allow the steering rod to move
freely back to the center position.
S T E P 5 Turning AG19 Around the Pole Axis
Loosen the base pole clamp by turning the clamp counter-clockwise. Turn the
umbrella to the desired position. Turn the clamp in a clockwise direction, to tighten.
(Fig. 10)
(Fig. 13)