Taser X26P - Manual (Page 8)

8
X26P ECD Features
Get to know the X26P ECD:
AFIDs
Wire
Probe
Blast Door
Mechanical Sights
TASER Cartridge
LASER
Low Intensity Lights (LEDs)
Cartridge Release Tab
Performance Power
Magazine (PPM)
Textured Grip Zones
Illumination Selector
Safety Switch
PPM Release Button
Trigger
NOTE: The serial number is located inside the cartridge bay.
WARNING
Ensure the ECD is unloaded, the safety is in the down (SAFE) position, and your fingers are away from the
trigger before reading the serial number.
Safety Switch
Ambidextrous safety can be operated from either side of the ECD.
• Safety switch down (SAFE).
• Safety switch up (ARMED) and ready to deploy.
• Do not block the safety on one side of the X26P ECD while attempting to move it on the other side. This
can break the safety and disable the ECD.
• With default settings, if the X26P ECD’s safety switch is left in the up (ARMED) position for more than 20
minutes, the system goes into low power mode to reduce the amount of power consumed, and the ECD
will not fire. The ECD will not fire, but power is still consumed and will eventually drain the battery if the
safety switch remains in the ‘ARMED’ position. (This feature can be turned off, which then will cause the
X26P ECD to be left on indefinitely when the safety is up (ARMED). See the Setting Auto Power Down
(Power Save) section in this manual for more information.) To re-arm the ECD, shift the safety to the
down (SAFE) position, and then shift it back to the up (ARMED) position.
Features
3