Taser X26P - Manual (Page 16)

16 Chapter 3 Features
NOTE: Using pens or paper clips to press the selector switch may damage it. Only use your finger to press the
selector switch.
5 Press and release the selector switch to toggle through the four available settings until the setting you
desire is designated on the CID. Stop when the setting you desire is displayed.
OO: Neither the LASER nor the Flashlight will illuminate.
LO: Only LASER will illuminate
OF: Only Flashlight will illuminate
LF: LASER and Flashlight both illuminate
The selected mode displays for 5 seconds, and will be the default mode the next time the safety switch is
moved to the up (ARMED) position.
The selector switch may also be used to activate the Stealth Mode, which will shut off the LASER and flashlight,
and dim the CID display. To do this, press the selector switch when the safety is in the up (ARMED) position. To
take the ECD out of Stealth Mode, press the selector switch again or shift the safety to the down (SAFE) position.
You will have to reactivate the Stealth mode each time you place the safety in the up (ARMED) position.
WARNING
Do not place your fingers or any part of your body in front of the cartridge when activating the Stealth
Mode.
Trigger Switch
Unlike a firearm trigger, the X26P ECD trigger is a momentary electrical switch. The switch is operational only
when the safety switch is in the up (ARMED) position. Pulling and releasing the trigger switch will result in
an approximately 5-second discharge cycle unless the safety switch is shifted to the down (SAFE) position to
discontinue the 5-second cycle. Pulling and holding the trigger switch for more than 5 seconds will result in
a continuous discharge until the trigger switch is released, or the battery is depleted—whichever comes first.