D-Link DP-311U - Manual (Page 10)

10
Setting up the DP-311U
Installing the Print Server
WARNING: Configuration problems may result if the Print Server is powered up without
first establishing its network connection. Follow this procedure to avoid complications at
the configuration stage.
Confirm proper operation of the printer to be connected to the DP-311U, 1.
When you have confirmed proper operation of the USB printer, switch it the
power OFF.
2.
Confirm that your network is operating normally. 3.
Connect the DP-311U RJ-45 Connector to the network, using a straight
through CAT5 cable..
4.
While the printer is powered OFF, install the USB printer cable to connect the
printer’s USB port to the USB port of the Print Server.
5.
Switch on the connected printer. 6.
Plug the AC power adapter’s DC output plug into the DC 5V power socket on
the rear panel of the Print Server.
7.
Plug the power adapter into a power outlet. This will supply power to the Print
Server, as it has no external power switch. The green Power LED on the
Print Server’s front panel should illuminate steadily, and the Print Server’s
Self-Test will proceed.
8.