Smart start activation – Directed Electronics 1.3X User Manual

Page 35

After exiting the vehicle, lock the system. The vehicle remains running for the
programmed runtime. (The remote start feature is still enabled).
You can still remote start the vehicle after the turbo timer has timed out and
shut Off the vehicle. For safety reasons, if a door is opened (while the system
is Locked or Unlocked) while you are away, the remote start exits the manual
transmission mode and will not remote start until the MTS sequence is re-
initiated.

➢

Smart start activation

Smart Start uses the hours and cycles settings used in Timer Mode, in addition

to temperature or voltage, to automatically start the engine. Activation begins

the countdown timer. When the timer expires the vehicle interior temperature

is checked and, if it exceeds the temperature or voltage thresholds the engine

starts. When the Remote start runtime expires the engine shuts off and the

countdown timer restarts. Smart Start is exited after the final start.

Note: This feature works only when the system has been locked with the

remote.

The factory setting for temperature high is 100º, and the low is 0º (F). The

voltage setting is 10.5v. These settings can be adjusted, or turned off by your

authorized Directed dealer using the Bitwriter.

To activate Smart Start mode:

•

Press the

button on the remote 3 times and then press the

A U

button.

The parking lights flash 5 times fast to confirm the remote is in Smart Start

mode.

To activate Smart Start mode with a manual transmission:

1. Enter the MTS procedure.

2. Exit the vehicle and press the button on the remote (the vehicle shuts

down when locking).

3. Press the

button on the remote 3 times and then press the

A U

button.

The parking lights flash 5 times fast to confirm the remote is in Smart Start

mode.