StorCase Technology DS321 - Manual (Page 16)

8 Installation
StorCase Technology, Inc. DS321 User's Guide - Rev. B00
Figure 4: Drive Installation Assembly
Drive Installation
1. Remove the DE110 drive carrier(s) from the DS321 chassis.
2. Uninstall the drive cover(s) from the drive carrier(s). Refer to Figure 5.
3. Attach the DC power cable (from the Drive Carrier Board) to the drive (Figure 4).
4. Carefully insert the drive into the carrier. Slide the drive towards the Drive Carrier
Board, so that the I/O connector on the drive mates with the connector on the Drive
Carrier Board (Figure 4). Make sure that the DC power cable is not pinched.
5. Fasten the drive into place with four (4) #6-32 Phillips Flat Hd. screws (Figure 4).
6. Reinstall the provided drive cover (Figure 5).
Drive
(Not Included)
Drive Carrier
Board
DC Power
Cable
#6-32 Phillips
Flat Hd. Screw
(4 each)
Drive
Carrier
0835