StorCase Technology DX150-KIT - Manual (Page 3)

DX150-KIT Installation 3
DX150-KIT User's Guide - Rev. B00 StorCase Technology Inc.
0383
Drive
(Not Included)
M3 x 5MM
Screws (4 ea.)
Drive Bracket
Drive Sits Flush with Drive
Bracket Filler Panel
Figure 3: Installing the Drive Into the Bracket
8. Place the Drive Bracket assembly into the carrier unit and fasten in place with four
(4) M3 Phillips flat hd. screws as shown in Figure 4.
9. Complete the installation by installing the cover (Figure 5). Carefully insert the sides
of the cover between the carrier and the drive. Slide the cover towards the rear of
the carrier making certain that the lip on the rear portion of the cover is underneath
the lip on the rear of the carrier. Fasten the cover to the carrier with two (2) #6-32
x .230" flat hd. screws.
5. If the drive requires jumper modifications or cable connections to the bottom of the
unit (refer to device manufacturer's manual for this information), make these
changes now, before installing the drive into the adapter bracket.
6. Attach the drive to the adapter bracket using four (4) M3 screws, as shown in
Figure 3.
7. Attach the ID select cable, the I/O and power cables to the drive. Refer to the Data
Express User's Guide and the drive manufacturer's documentation for information on
these procedures.