Installation, Installing the drive in the carrier preparation – StorCase Technology DE200i-SWCU2 User Manual
Page 14
Installation
7
DE200i-SWCU2 User's Guide - Rev. A01
StorCase Technology, Inc.
INSTALLATION
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation pro-vided with
the drive.
NOTE:
A #2 Phillips screwdriver will be required during this procedure.
1.
Remove the drive from its protective packaging.
2.
Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3.
SCSI Drive Termination: The DE200i-SWCU2 does not provide onboard
termination. External termination must be provided. Refer to the documen-tation
provided by the drive manufacturer for termination information.
Installation
1.
Carefully insert the drive (Figure 6) into the carrier so that the I/O connector is
flush with the rear of the carrier.
2.
Fasten the drive into place with four (4) #6-32 Phillips Pan Hd. screws (Figure
6).