Starrett 5001 Carbon Fiber Caliper - Manual (Page 2)

2
LCD Display
Indicator of Min Max Mode 1.
Indicator of Reference Mode 2.
Measured value 3.
Negative sign 4.
Battery life warning display 5.
Indicating cursor for Preset and Tolerance 6.
Indicator of Measuring unit 7.
Indicator of Tolerance Mode 8.
Indicator of Preset Mode 9.
Indicator of Set Mode 10.
Indicator of Set Mode Display .0005" / .010mm 11.
Hold indicator 12.
Taking Measurements
Measurements can be taken from: SET, REF I,
REF II, MIN / MAX, and TOLERANCE Modes
Mode
There are 5 Modes available: SET, REF
I & REF II, PRESET, MIN / MAX, and
TOLERANCE.
To change between Modes:
Press and Hold
MODE
Set Mode
Set Mode can calibrate / zero the tool to
a Preset Reference Value (see Reference
Mode), and to change the units-of-mea-
sure.
Note: If measurements are to be taken
from this mode, the Hold function is not
available, and when the SET key (also
used as ZERO and HOLD) is pressed, the
display will be zeroed to the REF I or II
preset value.
To enter the Set Mode:
Press and Hold
MODE until INCH/MM and
SET appears
To change between MM / INCH:
Press and Release
MODE
To calibrate / zero the tool:
Press and Release
SET
MEASUREMENTS CAN NOW BE TAKEN