Porter-Cable H1000IS - Manual (Page 11)

11- ENG D28469
5. Lift generator and remove 2x4.
6. Lift other end of generator and
place two 2x4s between generator
and pallet as shown.
7. On the muffler side of the engine, remove cap screws
and flange nuts holding the heat shield to the frame.
Reassemble cap screws, heat shield, wheel bracket,
and flange nuts and as shown. Tighten securely.
8. On other side, assemble wheel
bracket using cap screws and flange
nuts supplied. Tighten securely.
NOTE: Brackets are placed under frame
with hole facing outward.
9. Using a hammer tap axle cap onto end of axle,
without the hole
.
10. Slide wheel onto axle with valve stem to the
outside.
11. Slide spacer onto axle against wheel.
12. Slide axle through axle brackets. NOTE: The pallet
will need to be removed before the wheel can be assembled.
13. Lift generator and slide pallet and 2x4s out. NOTE: Generator will tilt.
14. Lift generator and slide spacer, then wheel (with valve stem to the outside)
onto axle.
15. Slide flat steel washer onto axle against wheel.
16. Secure with cotter pin.
Cap screws
Wheel Bracket
Hole in Axle
Muffler
Heat
Shield
Cap
Screw
Wheel
Bracket
Flange Nuts
2x4