Porter-Cable H1000IS - Manual (Page 10)

10- ENG D28469
1. Lift the gas tank end of generator
and slide 2x4 between generator
and pallet as shown.
The generator is too
heavy to be lifted by
one person. Obtain assistance from
others before lifting.
2. Place handle grips on handle assemblies.
3. Place one 5/8” washer into the bottom of
each end cap. Push end caps onto the
end of the handle assemblies.
4. Attach handle assemblies to frame
using four screws and flange nuts.
NOTE: Screw on outside of frame.
NOTE: Do not tighten until all screws
and flange nuts are assembled.
Screws and
Flange Nuts
2x4
Gas Tank
Handle Grip
End Cap
5/8” Washer
Handle
Assembly