Datalogic Scanning DLL2020 - Manual (Page 16)

INSTALLING THE DLL2020
9
2
2 INSTALLING THE DLL2020
2.1 CONNECTING THE SCANNER
This chapter describes the instructions necessary for installing the
DLL2020 scanner.
Due to many POS systems on the market, a large number of
communication cables is available. Make sure that you have the right
cable to connect the scanner to your POS or computer.
NOTE
The scanner and the host system must be switched off
before starting the installation of the scanner. By
following this precaution you prevent any electrical
damage.
You are advised to install the scanner in an air
circulated place out of direct sunlight.
Follow these steps carefully in order to install the scanner:
1. Locate the optimal scanner position in relation to the counter
surface.
Pay attention to the product flow, the distance to the counter edge
and convenience for the operator.
2. You have two options to connect the scanner to your POS or
computer.