Dual XML8110 - Manual (Page 7)

7
XML8110 OPERATION
Power On/Off
Mode
Steering Wheel Interface
Input
Volume
Mute
Reset
Display
Set the Clock
12/24-Hour Clock
Expansion Slot
General Operation
Press the red power button or any other button to turn the
unit on. Press and hold the red power button to turn the unit
off.
Press MODE to select between AM/FM, Auxiliary input,
Bluetooth and iPod modes. Modes of operation are indicated
in the display.
Note: iPod mode will not appear unless an iPod has been
connected using the in-dash iPod dock located behind the
front panel. Bluetooth mode will not appear unless the
BTM60 Bluetooth module is connected.
The steering wheel interface input located on the back of the
head unit allows connection to the PAC (Pacific Accessory
Corporation) SWI-PS interface module (sold separately). Visit
www.pac-audio.com for details.
To configure steering wheel controls, follow the instructions
provided with the PAC SWI-PS interface module. After
installing the interface module, insert the module's 3.5mm
jack into the port on the back of the head unit.
Adjust volume using volume knob (00-46).
Press to silence the audio. “MUTE” will flash in the
display. Press again to cancel.
Press to RESET the unit upon initial installation or if
abnormal operation occurs. The reset button is located to the
right of the iPod dock.
Press DISP to toggle between items such as clock and radio
frequency.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Press TUNE
nn
to adjust the
hours and TUNE ll to adjust the minutes. Press DISP
momentarily to save the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
The expansion slot provides an easy way to upgrade the
XML8110 with new features. Check www.dualav.com for
more details.