Dual XML8110 - Manual (Page 14)

14
Bluetooth
®
Operation
XML8110 OPERATION
Overview
Connecting a Bluetooth device requires first installing and connecting the Dual BTM60
Bluetooth interface module (sold separately). When connected to a Dual Bluetooth ready
head unit, the BTM60 supports the HFP (hands-free profile), A2DP (advanced audio
distribution profile) and AVRCP (audio video remote control profile).
Preparation
Before you can use a mobile device with this head unit, it must be paired and connected.
Please make sure that Bluetooth is activated on your mobile device before you begin the
pairing process. Refer to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to your head unit, press on the head unit
or BTM60, or press MODE until "DUAL_BTM60" is displayed.
2) Press and hold on the head unit or BTM60 for 5 seconds, until "PAIRING" is
displayed, the Bluetooth icon will flash every second. The head unit will begin to
broadcast the pairing signal for 90 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching
for new devices. Please refer to your mobile device instructions for further information
on Bluetooth pairing and connections. The Bluetooth icon will illuminate solid when
connected.
The BTM60 device name is "DUAL_BTM60."
The password for the DUAL BTM60 is 1234.
Compatibility
• Due to the differences in Bluetooth technology, some mobile devices may be
incompatible or function improperly when used with the BTM60.
Paired Devices List
The XML8110 will remember the last 8 devices that were paried. To access the list of
previously paired devices, follow these instructions:
• Disconnect any mobile device that may be connected by pressing once.
• Press DISP momentarily to cycle through the list of 8 previously paired devices.
• When stopped on a device number 1-8, wait 5 seconds to see the name of the device.
• If the device is not in range of the BTM60, "Unknown" will be displayed.
• Once the desired device is displayed, press or the center select button to connect.
Connection Notes
• If AUTO-CON is set to OFF, you must press to connect after pairing, and every time
the XML8110 is turned on.
• From Bluetooth standby mode, press to disconnect your mobile device from the
BTM60. If disconnected, press to reconnect the mobile device that was connected last to
the BTM60.