beautypg.com

DeVillbiss Air Power Company DVH2600 User Manual

Page 4

background image

4- ENG

A16064

RISK OF FLUID INJECTION AND LACERATION

WHAT CAN HAPPEN

HOW TO PREVENT IT

• Your pressure washer operates at

fluid pressures and velocities high
enough to penetrate human and
animal flesh, which could result in
amputation or other serious injury.
Leaks caused by loose fittings or
worn or damaged hoses can result
in injection injuries. DO NOT TREAT
FLUID INJECTION AS A SIMPLE
CUT! See a physician immediately!

• Inspect the high-pressure hose

regularly. Replace the hose
immediately if it is damaged,
worn, has melted from contacting
the engine, or shows any signs
of cracks, bubbles, pinholes, or
other leakage. Never grasp a high-
pressure hose that is leaking or
damaged.

• Never touch, grasp or attempt to

cover a pinhole or similar water
leak on the high-pressure hose.
The stream of water IS under high
pressure and WILL penetrate skin.

• Never place hands in front of noz zle.
• Direct spray away from self and

others.

• Make sure hose and fit tings are

tightened and in good condition.
Never hold onto the hose or fittings
during op er a tion.

• Do not allow hose to contact muf fler.
• Never attach or remove wand

or hose fittings while sys tem is
pressurized.

• Injuries can result if system pressure

is not reduced before attempting
maintenance or disassembly.

• To relieve sys tem pres sure, shut off

engine, turn off water sup ply and
pull gun trigger until water stops
flowing.

• Use only hoses and accessories

rated for pressure higher than your
pressure washer's PSI.

RISK OF INJURY FROM SPRAY

WHAT CAN HAPPEN

HOW TO PREVENT IT

• High-velocity fluid spray can cause

objects to break, propelling particles
at high speed.

• Light or unsecured objects can

become hazardous projectiles.

• Always wear ANSI-approved Z87.1

safety glasses. Wear protective
clothing to protect against
accidental spraying.

• Never point wand at or spray people

or animals.

• Always secure trigger lock when

wand is not in service to prevent
accidental operation.

• Never permanently secure trigger in

pull-back (open) position.

This manual is related to the following products: