Simaudio 820S Power Supply - Manual (Page 7)

820S Power Supply
____________________________________________________________________________________
7
Unpacking
The MOON 820S power supply should be removed from its box with care.
The following accessories should be included inside the box with your power supply:
9 AC power cable
9 Two (2) 4-Pin XLR cables for analog section DC power
9 Two (2) 5-Pin XLR cables for digital section DC power
9 This owner’s manual
9 Warranty and product registration information (USA and Canada only)
Once the 820S is unpacked, inspect it thoroughly
and report any damage to your dealer immediately.
We suggest that you keep all of the original
packaging, storing it in a safe, dry place in case
you’re required to transport this product. The
customized packaging is specially designed to
protect the 820S from any potential damage during
transit.
Please write the serial number of your new MOON 820S in the space provided below for future reference.
Serial No.: ________________
Installation & Placement
The MOON 820S power supply should be placed on
a solid level surface. You should never place another
component directly on top of, or underneath this
power supply. If you wish to stack the 820S with
other MOON Evolution series components, we
suggest using a set of MOON Bridges, which have
been designed specifically for this purpose. Consult
your authorized MOON retailer for further details.
The MOON 820S uses two toroidal transformers in
its power supply; even though they are extremely
well shielded, you should not place this power
supply too close to source components such as a
turntable, phono preamplifier or CD Player. There
should be at least 2 inches of space between the
chassis’ of the 820S and any of your source
components.
If the surface you have chosen isn’t perfectly level,
each of the four (4) cones of your 820S are height
adjustable; carefully using your fingers, you can
either raise each leg by turning the cone underneath
clockwise, or lower each leg by turning it
counterclockwise.
We strongly recommend that you leave these cones
mounted to the component at all times for reasons
related to both performance and aesthetics.