Simaudio Neo 380D DAC - Manual (Page 12)

380 D Digital to Analog Converter
____________________________________________________________________________________
12
Remote Control Operation
The Nēo 380D Digital-to-Analog Converter uses the ‘CRM-2’ full-function
remote control (figure 6). It operates on the Philips RC-5 communication
protocol and is can be used with other Simaudio MOON components.
The ‘CRM-2’ remote uses two AA batteries (included). To install them,
simply slide the back plate off in the direction of the arrow; insert the
batteries in the correct direction and then replace the back plate.
To engage the ‘CRM-2’ remote for use with the Nēo 380D,
you must first
press the button labeled D/A.
The POWER button located on the upper left will switch the Digital-to-
Analog Converter to either ‘Standby’ or ‘On’ mode.
The DISPLAY button turns the front panel display on and off.
The 2 buttons labelled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all eight (8) available inputs. For example,
to switch from “D4” to “D1” you may press either ◄ INPUT three (3)
times or INPUT ► five (5) times. Pressing and holding down either
of these buttons results in only a single change to the selected
input.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
For MOON 380D’s equipped with the optional volume control:
The 2 buttons labelled ▼ VOL ▲ allow you to control the volume level.
Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲
results in an increase in the volume level. You may either press and hold
these buttons down or press them briefly to make volume adjustments.
NOTE: The buttons labelled ◄ BAL ► don’t affect the operation of the 380D.
Figure 3: CRM-2
Remote Control