Simaudio 740P Preamplifier - Manual (Page 12)

740P Dual-Mono Preamplifier
____________________________________________________________________________________
12
Only one of the five inputs may be configured for
the MiND. “B1” is the default input. If, in the
previous section, you already assigned the “MiND”
label to one of this preamplifier’s inputs, then there’s
nothing required to do here – The corresponding
input has been automatically configured for MiND
and cannot be changed until you change the input
‘LABEL” assigments. However, if you haven’t
assigned the “MiND” label to one of the 740P’s
inputs, the following example shows how to
configure an input for MiND functionality:
1. You may either continue where we left off in the
previous example by pressing “Setup” twice to
return to the main menu and the turn the
volume control until “MiND” appears in the
display OR enter into the “Setup” mode from the
beginning by pressing the “Setup” button and
rotating the volume control until “MiND” appears
in the display.
2. Press “OK” and “MiND:B1” will appear in the
display.
3. Rotate the volume control clockwise until the
input you want to configure appears in the
display.
4. Press “OK” and “SAVED” will appear brielfy in
the display followed by “MiND”.
5. Press the “Setup” button and “EXITING” will
appear in the display.
The MOON 740P is equipped with a 12 Volt trigger
output. When an input is assigned to the 12 Volt
trigger, the device connected to the trigger will
automatically start-up whenever you switch to that
input. The default setting for all five inputs is on.
When you set the IR input to “Y”, all inputs
previously set to “Y” for that trigger will
automatically be set to “N”. Then the trigger will be
controlled exclusively by an external IR signal. The
following example shows how to configure one of
them:
1. You may either continue where we left off in the
previous example by pressing “Setup” twice to
return to the main menu and the turn the
volume control until “TRIG 1” appears in the
display OR enter into the “Setup” mode from the
beginning by pressing the “Setup” button and
rotating the volume control until “TRIG 1”
appears in the display.
2. Press “OK” and “B1 : Y” will appear in the
display.
3. To disable the 12 Volt trigger, press “OK” and
“B1 ? Y” appears in the display; rotate the
volume control to alternate from “Y” to “N” .
4. Press “OK” and “SAVED” will appear brielfy in
the display followed by “B1 : N”.
5. To configure another input, rotate the volume
control until that input appears in the display,
then press “OK”.
6. Repeat steps 3 and 4.
7. When you have finished with all of the inputs for
the “TRIG 1” press the “Setup” button and
“TRIG 1” will appear in the display. From this
point you may go to three different locations in
the Setup menu:
• To exit from the Setup procedure, press the
“Setup” button again and “EXITING” will
appear in the display.
• To reset the software settings back to their
factory defaults, rotate the volume control
until “RESET” appears in the display (see
the next example).
• To configure the inputs (previous example)
rotate the volume control until “INPUT”
appears in the display.