Rocktron Velocity 250 - Manual (Page 3)

Contents
Contents
Your Velocity 250 has been tested and complies with the following Standards and
Directives as set forth by the European Union:
Council Directive(s): 89/336/EEC Electromagnetic Compatibility
Standard(s): EN55013, EN50082-1
This means that this product has been designed to meet stringent guidelines on
how much RF energy it can emit, and that it should be immune from other sources
of interference when properly used. Improper use of this equipment could result in
increased RF emissions, which may or may not interfere with other electronic
products.
To insure against this possibility, always use good shielded cables for all audio
input connections. This will help insure compliance with the Directive(s).
Introduction ............................................................................................... 1
Velocity 250 Design .................................................................................. 2
Front Panel ................................................................................................3
Rear Panel .................................................................................................. 4
Connections ............................................................................................... 5
Stereo Applications ..................................................................................... 5
Mono Bridged Applications .......................................................................... 6
Operating Precautions .............................................................................. 7
Power Output/Speaker Load ....................................................................... 7
Fuse Replacement ...................................................................................... 8
Other Features .......................................................................................... 9
Automatic Short Detection .......................................................................... 9
Definition Control ......................................................................................... 9
Specifications .......................................................................................... 10