Rocktron Velocity 120 - Manual (Page 6)

3
Rear Panel
Rear Panel
1 OUTPUT jacks (Ch. 2)
2 INPUT jack (Ch. 2)
3 BRIDGED MODE selector switch
4 OUTPUT jacks (Ch. 1)
5 INPUT jack (Ch. 1)
6 POWER INLET module
These standard ¼" jacks provide outputs for Channel
2 to speaker cabinets. Do not connect these outputs to
a load of less than 4 ohms (or less than 8 ohms in
mono-bridged mode). These jacks are inoperable
when using the Velocity
® 120 in "bridged" mode (i.e
MONO BRIDGE switch "in").
This standard ¼" jack provides an input to Channel 2
from the output of your preamp or the last device in
your effects chain.
This jack is inoperable when using the Velocity
® 120 in
"bridged" mode (i.e MONO BRIDGE switch "in").
When pressed "IN" the Velocity ® 120 operates as a
mono unit with increased output power (Channel 2
becomes inoperable in this condition).
In the "OUT" position the unit operates as a normal
stereo amplifier.
These standard ¼" jacks provide outputs for Channel
1 to speaker cabinets. Do not connect these outputs to
a load of less than 4 ohms (or less than 8 ohms in
mono-bridged mode). These jacks are the operable
output jacks when using the Velocity
® 120 in "bridged"
mode.
This standard ¼" jack provides an input to Channel 1
from the output of your preamp or the last device in
your effects chain.
This jack is used as the input jack when operating the
Velocity
® 120 in "bridged" mode.
This module provides a connection for the power cord
and also houses the main fuse of the unit. (For infor-
mation about changing the fuse, see page 7).