Rocktron Velocity 100 - Manual (Page 6)

3
Rear Panel
1 IN jack (Ch.2):
This ¼" jack provides an input to Channel 2 from the output of a preamp or the device in an
effects chain.
2 OUTPUTS jacks (Ch. 2):
These ¼" mono jacks provide outputs for Channel 2 to speaker cabinets. These jacks are
configured in parallel.
Important!
Do not use these outputs with loads of 2
Ω
or less. When using both
output jacks to provide multiple speakers for a given channel, it is
important to ensure that the combination of speaker impedances for the
given Velocity 100 output channel does not equate to a combined
impedance of 2
Ω
or less.
3 POWER module
This module provides a connection for the power cord and also houses the main fuse of the
unit. (For information about changing the fuse, please see page 5.)
4 OUTPUTS jacks (Ch. 1):
These ¼" mono jacks provide outputs for Channel 1 to speaker cabinets. These jacks are
configured in parallel.
Important!
Do not use these outputs with loads of 2
Ω
or less. When using both
output jacks to provide multiple speakers for a given channel, it is
important to ensure that the combination of speaker impedances for the
given Velocity 100 output channel does not equate to a combined
impedance of 2
Ω
or less.
5 IN jack (Ch.1):
This ¼" jack provides an input to Channel 1 from the output of a preamp or the device in an
effects chain.