Rocktron Piranha User Manual

Page 16

G. Using the Piranha with a Rocktron All Access™ in REMOTE mode

A Rocktron All Access

™

can act as a dedicated remote control for the Piranha - allowing direct access to specific

Piranha features from the footswitch at any time.

Setting up the Piranha for remote operation

When the Piranha is turned off, set the rear panel MIDI Channel selection

switch to MIDI channel "1" as shown below. (The Piranha must be set to MIDI

channel 1 to respond to the All Access remote function.)

Note:

Changing the MIDI Channel status to any MIDI channel other than channel 1
will defeat remote mode operation.

Connect the MIDI OUT on the All Access

to the rear panel MIDI IN/REMOTE

connector on the Piranha.

(All switches in the "up" position
selects MIDI channel "1".)