RAVE Sports Waterboggan 12 - Manual (Page 12)

For best performance and stability in turns:
• When pulling one rider, the rider should always be positioned in the center
of the tube. Do not stand.
• When pulling two riders, they should be position towards the outside
position and rider weights should be as equally balanced as possible. Do not
stand.
• When pulling three riders, balance the weight of the outer two riders as
equally as possible, placing the odd weight rider (lighter or heavier) in the
center position. Do not stand.
Note: To avoid damaging the rooster tail device (if product contains a “RAVE
tail”)
• Do not drag the product on the ground.
• Do not store product in excessively hot area.
• Do not tow or sit in the product while it is in contact with the ground.
• Avoid extreme shallow water starts as the weight of the rider(s) can
depress the rooster tail device into the lake bottom causing damage during
takeoff.
• NOTE: Ensure the outer edge seam of the bladder is aligned with the cover
seam and is spread out evenly within the cover. A misaligned cover can
cause distortion and less than optimal performance of the tube and rooster
tail.
• NOTE: If your tube has a RAVE tail; it is highly recommended that you keep
the cardboard insert shipped in the RAVE tail to be reinserted during
storage to maintain the shape of the device.
Troubleshooting
Air chamber(s) won’t hold air:
• Check stem valves to ensure plugs are fully seated down into the valve
body.
• Check main Boston valve to ensure plastic ring is not caught under the seal
or cap.
• Check for holes in bladder following the procedures in the “Repair” section.
Repairs
For minor holes or tears:
 Remove the inner bladder from the cover.
12