RAVE Sports O-Zone Slide - Manual (Page 6)

5
W A R N I N G
• Never use the product in rough surface water conditions,
during storms, or when there is lightning. If an
unexpected storm arises while using the O-Zone Slide,
seek shelter on shore. Do not stay on the product.
• Always stay under control while using the product.
• Inspect the O-Zone Slide before each use for worn or
damaged parts.
• Never use product while tired or fatigued. Use extreme
caution while swimming between the shore and the O-
Zone Slide. Do not attempt to swim this distance if you
are tired or fatigued.
Troubleshooting
Won’t hold air:
• Check main valve to insure plastic ring is not caught under the
seal or cap.
• Be sure the valve and cap are screwed in straight and tight. A
cross threaded valve can cause leakage.
• Check stem valves to insure plugs are fully seated down into
valve body.
• Check for holes in product following the procedures in the
“Repairs” section.
Repairs
• Inflate the tube firmly and locate the leak by spraying the tube
with soapy water. Bubbles will appear where there is a leak.
• Determine the hole size and cut a circular patch ½ - 1 inch wider
than the hole.
• Remove air from the tube and dry tube completely where the
patch is to be applied.
!!