RAVE Sports O-Zone Slide - Manual (Page 4)

3
Inflating and connecting the O-Zone Slide
1. Inflate the main body chamber of the slide. DO NOT OVER
INFLATE. Inflate until firm and the slide stands upright.
2. Inflate both side rails on top of slide until firm. DO NOT OVER
INFLATE as the heat of the sun will cause the air to expand.
Release air throughout day if necessary.
Note: Moisten the plug of the clear stem valve prior to inserting it
into the valve and push plug into the valve body fully.
3. Carry slide to the water and position
next to the O-Zone directly opposite
from the boarding platform.
4. Tie a knot at one end of each slide
attachment rope.
5. Working from the top down, feed the
rope through mounts A through F as
shown. Loop twice through point E and
finish by tying at point F.
6. Lace other side of slide in the same
fashion.
7. Adjust connection lacing, if necessary,
to provide equal tension on both sides
and to ensure the slide is squarely and
securely fastened to the O-Zone.
Before using your O-Zone Slide, please read and follow all warnings
and safety instructions.
E