RAVE Sports Splash Zone Plus 12' - Manual (Page 11)

Product Assembly
Attaching the Slide
Connect the Slide attachment to the bouncer by placing both
units against each other and lining up the loops on each side.
Unit must be on level ground to attach.
NOTE: It is easier to attach to bouncer before inflating.
Remove grey cap from PVC tube, run cap attachment cord
below the loops. Apply a thin film of liquid dish soap to the
plastic tube, and then feed through the loops. Place grey cap
back onto open end of tube to secure it in place.
Attaching the Log
With Log still deflated, attach via the loops and PVC tube
(same as slide procedure above). Inflate the Log, and then
wrap the black straps around the main tube of the bouncer.
If one strap is longer than the other, always wrap that one
over the top of the trampoline and the shorter one under.
They will meet on the inside of the trampoline and under the
jump mat. Thread the straps through the buckle as shown
below. Pull tight.
10