Portable Winch AC Electric pulling/lifting winch PCT1800-60Hz-P User Manual
Page 7
7
3) Figure 3: Remove the drum from the
shaft. If necessary, you may push it
forward with two screwdrivers. Make
sure that the shaft key stays in place.
4) Figure 4: Insert the 57 mm (2-1/4
’’)
drum on the winch shaft. Insert the
washer, the 117 mm (4-
5/8’’)
safety lip
and the spacer bushing on the hex bolt
and insert this assembly in the hole of
the shaft. Then, tighten the hex bolt with
the 11 mm (7/16’’) wrench;
5) Figure 5: Insert the new rope guide in
position and tighten it using the two (2)
bolts.
IMPORTANT: Make sure that the rope
guide is not in contact with the capstan
drum.
3.0 Winch usage
MOST WINCHING
SITUATIONS PRESENT POTENTIAL
DANGERS!
The winch must be plugged into a grounded
plug. The use of an extension cord can cause
a loss of power at full capacity. As listed on the
product label (figure 1), make sure the voltage
and current type are respected. Units
115V-60hz require 20 amps while the units 220V-50hz require 10 amps.