Portable Winch AC Electric pulling/lifting winch PCT1800-60Hz-P - Manual (Page 6)

6
ACCESSORIES IN ACCORDANCE WITH THE JOB TO BE DONE. IN THIS CASE (LIFTING),
IT IS RECOMMENDED TO HAVE A 10 TO 1 SAFETY FACTOR FOR ALL ACCESSORIES.
IT IS STRICTLY FORBIDDEN TO:

LIFT LOADS WITH A WEIGHT GREATER THAN TO THE RATED LIFTING CAPACITY
(250 KG (550 LB);

TO LIFT LOADS THAT IMPAIR THE OPERATOR’S VISIBILITY OR THAT COULD
COLLIDE WITH OTHER MOVING LOADS OR WITH ADJACENT STRUCTURES;

USE THE WINCH TO LIFT PEOPLE;

ALLOW PEOPLE TO PASS UNDER A SUSPENDED LOAD;

LIFT LOADS THAT ARE POORLY SLINGED;

LEAVE SUSPENDED LOADS UNATTENDED;

ALLOW OTHER PEOPLE TO USE THE WINCH.
2.0 Before first use
2.1 Upon receiving the winch
Inspect the box to detect any apparent damage. If there is damage or missing parts, inform the
carrier immediately.
2.2 Capstan drum
Your PCT1800 AC Electric Portable Capstan Pulling/Lifting Winch
TM is equipped with the 85 mm
(3-3/8") diameter capstan drum and the 127 mm (5") diameter safety lip.
If you wish to change the drum for the 57 mm (2-1/4") drum (sold separately), you will also need
to purchase and install the 117 mm (4-5/8
’’) diameter safety lip. To do so, follow these simple
steps:
The tools required to change the drum are:

A 4 mm (5/32") hex wrench (included
with your winch).
 An 11 mm (7/16’’) wrench or adjustable
wrench (not included).
1) Figure 1: Remove the two bolts holding
the rope guide and then, remove the
rope guide;
2) Figure 2: Remove the hex bolt holding
the safety lip and drum using the 11 mm
(7/16’’) wrench. Then, remove the
washer, the safety lip and the spacer
bushing;