Portable Winch Gas-powered pulling/lifting winch PCH1000 - Manual (Page 34)

34
41 44-0022 LABEL - ROPE DANGER 1
42 44-0026 LABEL - ROPE INSTALLATION PCH1000 - PCT1800 1
43 44-0033 LABEL - SPECS SPEED VS DRUM DIAMETER PCH1000 1
44 45-0036 HOUR METER 1
4.6 Technical data
Engine: 4-stroke Honda GXH-50cc
Maximum pulling force (single line):
o 57 mm drum: 775 kg (1700 lb)
o 85 mm drum: 540 kg (1190 lb)
Rated lifting capacity (single line):
o 57 mm drum: 250 kg (550 lb)
o 85 mm drum: 175 kg (385 lb)
Speed:
o 57 mm drum: 12 m/min (40 ft/min)
o 85 mm drum: 18 m/min (60 ft/min)
Installed Capstan drum: 57 mm (2- 1/4’’) diameter
o Up to 4 wraps of 12-13 mm (1/2’’) rope
Gear box: Aluminum alloy; Gear ratio 110:1
Unit weight: 19 kg (42 lb)
Clutch: Centrifugal
Rope grabbing system (can be disabled)
Dimensions (overall): Length 50,5 cm x Width 36,6 cm x Height 36,6 cm (19-7/8
’’ x 14-3/8’’
x 14-3/8
’’)
Rope: Double braided polyester (not included) – Unlimited rope length
o Minimum diameter: 12 mm (1/2’’)
o Maximum diameter: 13 mm (1/2’’)
o Recommended rope with buried eye splice
4.7 Noise emissions
Here are the different noise emissions of the Portable Capstan Pulling/Lifting Winch
TM
:
Sound pressure level at operator position – L
P
A (measured)
o Engine idling: 73 dBA
o Full throttle: 89 dBA
Sound power level – L
W
A (measured)
o Engine idling: 85 dBA
o Full throttle: 102 dBA
Guaranteed sound power level – L
W
A : 105 dBA
4.8 Inspection
This section applies to winches used for lifting. The term inspect implies that any minor repair,
tightening, part replacement, cleaning, adjustment, etc, that can be performed during the
inspection procedure is done.
The procedures below are intended to provide a guide to the end-user to help maintain
compliance with ASME/ANSI Standard B30.7-201 and ISO Standard 14492-1:2006. Local
authorities may require other periodic test procedures.
Figure 37 Figure 38
Figure 37 Figure 38