Dolby Laboratories P/N 91659 - Manual (Page 8)

DolbyRemote Installation and Operation Introduction
1-2
1.3.2 Encoder Firmware
DolbyRemote requires the following encoder firmware:
DP561 Version 6.30 or later
DP567 Version 1.50 or later
DP569 Version 1.11 or later
1.4 Software Installation
The DolbyRemote application is installed from two diskettes.
1. Remove any previously installed version of DolbyRemote using the Add/Remove
Program command from the Control Panel.
It is strongly recommended that you exit all Windows programs before beginning the
installation.
2. Insert the DolbyRemote Software Install Disk 1 into the computer.
3. Click Start and Run.
4. Browse to the DolbyRemote diskette. Select setup.exe and click OK.
5. Please read the Limitation of Liability and Welcome screens before proceeding
with the installation.
6. The default installation destination for DolbyRemote is C:\Program Files\Dolby
Laboratories. Click Next to accept the default or click Browse to select an
alternative location.
7. Use the program folder default Dolby Laboratories or enter an alternate folder
name and click Next.
8. Insert the DolbyRemote Software Install Disk 2 when prompted to do so and click
OK.
9. To use the Help files in HTML format, click Yes. When the update is complete
click OK. If a previous copy of DolbyRemote has been installed this prompt may
not appear.
10. DolbyRemote installation is complete.