Physitemp Instruments TCAT-2DF PAK 400 - Manual (Page 8)

OFF/ON
POWER
SWITCH
FEEDBACK
SENSOR
AUXILIARY
OUTPUT
TCAT-2DF
CONTROLLER
OPERATING INSTRUCTIONS
The TCAT-2 Controller parameters are set at the factory for the specific load supplied with it. If the
TCAT-2 has not been so supplied, see the Operating Manual for adjustment of the control parameters
1. Connect the thermocouple sensor to the blue Feedback Sensor Socket on the rear panel and
position the sensor.
2. Connect the load (heating pad or blanket) the Low Voltage 7-pin Output Socket on the rear of the
controller or to auxiliary AC output socket(s) 500W AC max.
3 Connect the controller power cord to a suitable AC outlet.
4. Turn on controller Power Switch (rear panel).
5. Set the control temperature:
a) Press SHIFT. A digit will flash.
b) Use UP and DOWN buttons to change
the flashing digit. Press SHIFT again to
select the next digit.
c) When all digits are changed, press
SET to enter new control temperature.
SPECIFICATIONS:
Operating Range: -200°C to +400°C
Resolution: 0.1°C
AC Input Voltage: 110-130VAC or 220-240VAC, 50 or 60Hz (see Operating Manual)
SPECIAL DISPLAY INDICATIONS:
Red lamp will be illuminated when power is being supplied to load.
VIEWING ANGLE
The two front feet can be flipped down to adjust the viewing angle. Rotate feet down and
towards the front until they lock in position. To return to original position, pull down slightly,
then rotate back.
Made in USA
SET UP
DOWN
Serial Number:
SV -15.0
PV -14.9
SHIFT
PHYSITEMP INSTRUMENTS INC
154 Huron Avenue
Clifton, NJ 07013 USA
Tel: 973-779-5577, Fax: 973-779-5954
RUN Display
SET Display
9010
4.0 OPERATING INSTRUCTIONS
The instruction label from the top of the instrument is reprinted here in case it is ever defaced.
4
R
QX P:\CW shared\TCAT\EB TCAT-2DF PAK 400 Rev 1