Peg-Perego Primo Viaggio Convertible 2014 - Manual (Page 17)

- 17 -
Installing your child restraint in the vehicle
2.1 Lap/shoulder belt (3-point) with
Switchable Locking Retractor (ELR —>
ALR) and free sliding latch plate. This type
of seat belt has a latch plate that moves freely
along the belt. To activate the ALR mode, pull
the belt all the way out. Some vehicles may
require another activation method (check
vehicle owner’s manual for details). Once
activated, the belt will not extend unless
allowed to retract all the way.
Rear facing installation can be done using
the ALR or a locking clip. In some vehicles,
the shoulder strap can tend to tilt the seat
sideways when tightened. In this case, a
locking clip may provide a better installation.
The use of a locking clip is explained on page
32.
Forward facing installation should be done
with the ALR and the lock off clips located on
the sides of the seat.
Mode detailed installation instructions begin
on page 28.
Important Note: The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate. The
vehicle belt must be properly tightened to secure
the Convertible seat to the vehicle.
ELR ALR
1
FF
RF
√