Peg-Perego Primo Viaggio 4-35 - Manual (Page 32)

- 32 -
Now that you have installed the base in
your vehicle, you are ready to install the
car seat on the base.
Holding the car seat by the handle, align
it over the base and press it rear facing on
the base until you hear the click (a). You
will not be able to move the car seat if it is
properly locked in place.
Important! Newborn children should be
properly reclined. If the seat reclines too
much, your baby can be ejected from the
seat in an accident. If too upright, it can
cause breathing problems.
When levelling the base follow
instructions at page 25.
Once the seat is installed on the base,
open the rear compartment and check if
the bubble has moved from the original
position. In case re-adjust the seat until
the bubble is in the correct position.
Installing the Car Seat on the Base