Peg-Perego Primo Viaggio 4-35 - Manual (Page 29)

- 29 -
Important! Not all the seat belts work in the same way. To make sure that the child car
seat is properly installed using your seat belts, read your vehicle owner’s manual. It will
suggest proper installation of a child car seat.
This section refers to base installation using a common lap/shoulder belt with sliding
latch plate and ELR or SLR retractor (see sections 2.1, 2.2 and 2.3 from page 18 for
additional details).
Make sure that your vehicle is parked on
level ground when you install the base.
Remove the seat from the base following
the procedure at page 25.
Position the base rear facing in the back
seat of your vehicle. Check the level
indicator and set the proper angle (a)
following the procedure at page 25.
Keep the latch connectors stored in their
housing. Open the lockoff clip as shown
in the picture (b) .
How to install the Base using your VEHICLE SEAT BELT