beautypg.com

Preparing for installation, Venting air to the outside, Recirculating filtered air – Defy Appliances DCH284 User Manual

Page 3

background image

Page 3

Preparing for installation.

The extractor hood has the ability to ei-
ther recirculate the filtered air back into
the kitchen, or to vent the filtered air
through an outside wall.
Decide on which option best suits you be-
fore commencing with the installation.

The extractor hood is intended to be
mounted onto a flat perpendicular kitchen
wall capable of supporting the weight of
the hood. (approximately 16 to 26 kg de-
pending on the model).

Tools required for installation:

An electric drill.

A 3.5 mm diam. steel drill bit.

8mm and 5mm diam. masonry drill bits

A star screw driver (Posi 2).

A ratchet with a 10mm socket and a
100mm extension.

A tape measure, masking tape and a pen-
cil.

Venting air to the outside.

When discharging the air into a ventila-
tion shaft or directly through the wall
into the open , please take note of the fol-
lowing:

Exhaust air from the extractor hood

must not be directed into a flue or
chimney which is used for exhausting
the fumes or smoke from other appli-
ances burning gas or fuels.

Please ensure that regulations concern-

ing the discharge of exhaust air have
been fulfilled. (SABS IEC 60335-2-31).


For optimum extractor hood efficiency use
a short, smooth, round air exhaust pipe with
as few bends as possible A 150mm diameter
exhaust pipe is recommended. Long box
section, narrowed or bent pipes will hinder
performance and increase noise levels.

Connecting a 150 mm diameter pipe:

Mount the pipe directly onto the air outlet
on the extractor hood.

Connecting a 125 mm or 100mm di-

ameter pipe: Attach a reducing connec-
tor (available from a specialist retailer)
to the air pipe and then attach to the ex-
haust-air duct.

DESCRIPTION

ITEM

QUANTITY

8mm wall plug
6mm screw
5mm wall plug
5mm screw

Self tapping screw

Slotted washer

4

6

10

4

Care must be taken during installation not
to obstruct these vents.
No ducting is required for this type of in-
stallation.

The extractor hood filters out solid particles
before the air is recirculated, via the vents
on the side of the upper chimney, into the
kitchen.

Recirculating filtered air.

Recirculate

filtered air

Exhaust air through a dedicted pipe

not shared with another fuel burning appliance.

ceiling

ceiling

ceiling

This manual is related to the following products: