Delta 50-665 User Manual

Page 7

Fig. 7

Fig. 8

Fig. 9

Fig. 11

Fig. 10

Position the remaining inlet elbow (K) Fig. 8, at the

underside of dust collector lid (C) as shown. Align the

mounting holes in inlet elbows (K) Fig. 8, with screws (J)

assembled to upper inlet elbow (H) shown in Fig. 7,

STEP 4, and fasten the upper and lower inlet elbows to

the cover with remaining two flat washers, lockwashers,

and locknuts (J) Figs. 7 and 8.

Place the sheet metal cylinder (L) Fig. 9, onto the

underside of the cover.

Align four holes in cylinder brack-

et, three of which are shown at (M), with four holes (N) in

the underside of cover and fasten with four 1/4-20 x 5/8

hex head screws, lockwashers, and locknuts (P) Fig. 10.

NOTE: Assemble screws from the top of the lid down-

ward. CAUTION: Sheet metal cylinder (L) is extremely

sharp; use protective gloves when assembling the sheet

metal to the underside of the lid.

Assemble safety grid (V) Fig. 11, over metal cylinder

(L) and fasten grid to cylinder with three pan head screws

(W) as shown in Fig. 12.