ParkZone PKZU2480 - Manual (Page 14)

14 EN
Additional Safety Precautions and Warnings
As the user of this product, you are solely
responsible for operating it in a manner that does
not endanger yourself and others or result in
damage to the product or the property of others.
• Always keep a safe distance in all directions
around your model to avoid collisions or injury.
This model is controlled by a radio signal subject
to interference from many sources outside your
control. Interference can cause momentary loss
of control.
• Always operate your model in open spaces away
from full-size vehicles, traffi c and people.
• Always carefully follow the directions and
warnings for this and any optional support
equipment (chargers, rechargeable battery
packs, etc.).
• Always keep all chemicals, small parts and
anything electrical out of the reach of children.
• Always avoid water exposure to all equipment
not specifi cally designed and protected for
this purpose. Moisture causes damage to
electronics.
• Never place any portion of the model in your
mouth as it could cause serious injury or even
death.
• Never operate your model with low transmitter
batteries.
• Always keep the aircraft in sight and under
control.
• Always use fully charged batteries.
• Always keep the transmitter powered ON while
the aircraft is powered.
• Always remove batteries before disassembly.
• Always keep moving parts clean.
• Always keep parts dry.
• Always let parts cool after use before touching.
• Always remove batteries after use.
• Always ensure failsafe is properly set before
fl ying.
• Never operate aircraft with damaged wiring.
• Never touch moving parts.
To remove the factory-installed landing gear:
1. Lift the end of the landing gear wire above the
stop.
2. Gently pull the landing gear toward the center
of the wing and away from the clips.
Install in reverse order, making sure the end of
the landing gear wire is inside the stop and the
vertical strut is toward the front of each wing.
Removing and Installing the Landing Gear
1
2