ParkZone PKZU1480 - Manual (Page 12)

12
EN
To Remove:
1. Press together the sides of the landing gear
to make the center loop thinner.
2. Pull the landing gear from the fuselage of
the
model.
To Install:
1. Press together the sides of the landing
gear to make the center loop thinner.
2. Push the center loop in the slot in the
bottom of the fuselage.
3. Release the landing gear, then pull gently
on the landing gear to make sure it is
fully installed.
Removing and Installing Landing Gear
Additional Safety Precautions and Warnings
As the user of this product, you are solely
responsible for operating in a manner that
does not endanger yourself and others
or result in damage to the product or the
property of others.
• Always keep a safe distance in all directions
around your model to avoid collisions or injury.
This model is controlled by a radio signal subject
to interference from many sources outside your
control. Interference can cause momentary loss
of control.
• Always operate your model in open spaces away
from full-size vehicles, traffi c and people.
• Always carefully follow the directions and
warnings for this and any optional support
equipment (chargers, rechargeable battery
packs, etc.).
• Always keep all chemicals, small parts and
anything electrical out of the reach of children.
• Always avoid water exposure to all equipment
not specifi cally designed and protected for
this purpose. Moisture causes damage to
electronics.
• Never place any portion of the model in your
mouth as it could cause serious injury or even
death.
• Never operate your model with low transmitter
batteries.
• Always keep aircraft in sight and under control.
• Always use fully charged batteries.
• Always keep transmitter powered on while
aircraft is powered.
• Always remove batteries before disassembly.
• Always keep moving parts clean.
• Always keep parts dry.
• Always let parts cool after use before touching.
• Always remove batteries after use.
• Always ensure failsafe is properly set before
fl ying.
• Never operate aircraft with damaged wiring.
• Never touch moving parts.