beautypg.com

Installing the wings installing sfg technology, Wing fences – ParkZone PKZ6580 User Manual

Page 8

background image

EN

1. Slide the wing tube (A) into the fuselage.

CAUTION: DO NOT crush or otherwise damage the wiring when

attaching the wing to the fuselage.

2. Install the left and right wing (B and C) over the wing tube and into the

wing slot of the fuselage while inserting the aileron servo connectors
through the provided holes.

3. Invert the fuselage so the landing gear is facing up. Secure the left and

right wings to the fuselage using the included screws (D).

4. Remove the screw (E) and the receiver cover (F) from the bottom of the

fuselage.

Tip: If needed, use hemostats or pliers to pull the servo connectors into
the fuselage.

5. Connect the aileron servos from the wings to the Y-harness connectors in

the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.

6. Replace the receiver cover and the screw.

Disassemble in reverse order.

IMPORTANT: Correct operation of the AS3X system requires connection of
both ailerons to the included Y-harness and the AILE channel of the receiver.

1. Carefully apply the included tape (A) to the wing fence base.

2. Align and install the left and right (marked L and R) top and bottom wing

fences (B) into the respective wing slots (C). The bottom fences have
integrated plastic skids, as shown.

If desired, apply a small amount of thin CA (cyanoacrylate adhesive)
to the fences and wings.

A

B

C

A

B

C

D

F

E

Installing the Wings

Installing SFG Technology

®

Wing Fences

8