ParkZone PKZ6375 - Manual (Page 13)

EN
1. Disconnect the fl ight battery from the ESC (Required for Safety
and battery life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the aircraft.
4. Recharge the fl ight battery.
5. Repair or replace all damaged parts.
6. Store the fl ight battery apart from the aircraft and monitor the
battery charge.
7. Make note of the fl ight conditions and fl ight plan results, planning for
future fl ights.
Maintenance After Flying
Disassembly
CAUTION: Always disconnect the fl ight battery from the aircraft before
removing the propeller.
1. Remove the screw (A) and spinner (B) from the collet (G).
2. Remove the spinner nut (C), propeller (D), spinner backplate (E), backplate
(F) and collet (G) from the motor shaft (H). You will need a tool to turn the
spinner nut.
3. Remove the 4 screws (I) from the motor mount (J) and the fuselage.
4. Disconnect the motor wires from the ESC wires.
5. Remove the 4 screws (K) and motor (L) from the motor mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• The propeller size numbers (8.25 x 5.5 (left wing) and 8.25 x 5.5R (right
wing)) must face out from the motor for correct propeller operation. The left
propeller (PKZ1022) is shown, while the required right propeller (PKZ1022R)
is not shown.
• A tool is required to tighten the spinner nut on the collet.
• Ensure the spinner is fully connected to the spinner backplate for safe
operation.
• When looking from the front, the left propeller turns clockwise and the right
turns counterclockwise. Change the direction the motor turns by changing
the connection of any 2 motor wires on the ESC.
Not all wiring shown.
C D G H
J
Service of Power Components
E
I
F
A B
K L
13