ParkZone PKZ4800 - Manual (Page 2)

3 4
Congratulations on your purchase of the ParkZone ®
Super Decathlon BL. Your Super Decathlon BL has
come with everything to get you in the air—all in one box.
You will only need to attach the wing and landing gear, as
well as charge the battery prior to flight.
We at ParkZone are committed to giving you the most
enjoyable flight experience you can have. In order to
have a safe and successful flight, we ask that you do not
fly until you have read these instructions thoroughly.
The Super Decathlon BL comes with a fully proportional
3-channel FM radio system, providing full control of
throttle, elevator and rudder. If you are not experienced
at flying one of HobbyZone’s 3-channel aircraft, or any
other 3-channel radio controlled aircraft, we recommend
that you do not fly this aircraft. If you still choose to fly,
you will need to seek the help of an experienced radio
control pilot during your first several flights.
Crash
damage is not covered under the warranty.
The ParkZone Super Decathlon BL is equipped with
the exclusive ZX10 radio system which utilizes 10-bit,
1024-step processing for high-fidelity control. It uses a
6-channel FM receiver with industry-standard 3-wire
servos.
The ZX10 system also features dual rates, allowing you
to fly how you feel most comfortable. Low rate limits
the travel of the control surfaces and offers smooth and
relaxing flight. High rate allows for full control at all times
for those craving the maximum performance of their
aircraft.
Introduction
Step 1 – Charging the Aircraft Battery
Step 2 – Installing the Transmitter Batteries
Step 3 – Installing the Landing Gear
Step 4 – Attaching the Wing
Super Decathlon BL
This charger uses unique circuitry that ensures an
accurate charge every time and protects your Li-Po
batteries from the dangers of overcharging. This
charger continually monitors the battery and
automatically stops charging when the battery is fully
charged. The balance charger will help avoid damaging
Li-Po cells.
DC Li-Po Balancing Charger Features:
• Charges 2-cell lithium polymer battery packs
• LED charge status indicator
• LED cell balance indicator
• 12V outlet power cord
You must charge the included Li-Po battery pack with a
Li-Po specific charger only (such as the included
charger). Never leave the battery and charger unattend-
ed during the charge process. Failure to properly follow
the instructions could result in a fire. When charging,
make certain the battery is on a heat-resistant surface. It
is recommended to charge the Li-Po battery immediately,
as it will be used in future assembly steps.
1. Insert 8 new AA batteries (supplied) into the
transmitter, observing proper polarity.
2. Turn the power switch on to ensure the batteries
have been installed correctly. Once this is
confirmed, turn the transmitter off.
1. Locate the landing gear within the packaging.
2. Slide one half of the landing gear into the
allotted slot in the fuselage until it locks into
place. Slide the other half of the landing gear into
the fuselage as you have done with the previous
one. Look into the fuselage to make sure the two
gear halves are pressed in snug against the
center of the landing gear support.
3. Make sure both parts of the landing gear are
secure and properly in place. They should feel
snug inside the fuselage when attached properly.
1. Locate the wing and wing strut screws.
2. Place the wing on the top of the fuselage, making
certain it is centered properly. Attach the wing
with four rubber bands that are included. Stretch
two of the rubber bands from the front to the rear
attach points. Stretch the last two diagonally
across the middle to the attach points.
3. Attach the wing struts to the fuselage. Locate the
two small Phillips screws and attach the strut to
the fuselage as shown. Once the screw is
tightened into the fuselage, you can loosen it
slightly to allow the slack of the strut to be
adjusted as needed.
4. Make sure that prior to each flight the wing is
properly centered on the fuselage. If the wing
is not centered properly, it is impossible to have
correct flight.
Charging the Aircraft Battery
1. The 12V DC 2S Li-Po balancing charger provides a
charge current of .8 amps. The typical charge time
for the included 7.4V 800mAh Li-Po is
approximately 40 minutes to 1 hour.
2. Locate the balancing charge lead on the
battery pack. Connect the battery pack to the
charger. Charge through the balance lead on the
battery pack.
3. Connect the charger to the 12V power outlet in
your automobile. Please note that some 12V
outlets require your vehicle to be running for the
outlet to be operational. It is not recommended to
charge batteries while the vehicle is in motion. The
LED will continually blink while the battery charges.
4. Charging is finished when the LED indicator
glows steadily.
Note: Damage to the charger and battery will occur if
you exceed the recommended maximum charge rate.
For charging outside of the vehicle, you may wish
to purchase a 12V DC extension with alligator leads
(HBZ6513). This will allow you to connect the charger
to a 12V battery or power supply.
BATTERY CAPACITY
MAX. CHARGE RATE
CHARGE TIME
800mAh 7.4V 2S Li-Po
.8 amps
60 minutes