ParkZone PKZ4175 - Manual (Page 4)

4
Attaching the Horizontal Stabilizer and
Rudder
1. Locate horizontal stab.
2. Carefully slide horizontal stab into fuselage, making
sure control surface horn is on top.
3. Use included strips (4 pieces) of clear tape to
secure stab to tail fillet. You should use 1 strip for
top and bottom of each side.
4. Locate rudder. Carefully snap tail wheel wire into
the clip on bottom of fuse, as shown.
5. Use the three pins that are supplied to connect
rudder to stab, as shown. Do this by pushing pins
in carefully.
6. Install keepers on backside to secure pins,
as shown.
7. Attach rudder and elevator pushrods to
respective control horns (outer holes of control
horns for both).
Note: It may be necessary to re-trim control
surfaces prior to flight.
Apply Tape
Step 2
Step 4
Step 5
Step 6
Step 7
Step 4
Step 3